Measuring Irradiance to infer Emissivity / Absorptivity
To avoid confusion between the symbol for surface area and absorptance when discussing Kirchhoff's law, the symbol for surface area (typically ) has been replaced with a symbol, .
Radiated Power from an Object
To find the total power radiated by an object, first multiply the radiant exitance by the object's surface area:
Since the radiant exitance for a blackbody (or a graybody with emissivity ) is given by
we can write the total power as:
Where:
- is the total radiated power (in watts),
- is the surface area of the object (in square meters),
- is the radiant exitance (in watts per square meter),
- is the emissivity of the object (unitless, between 0 and 1),
- is the Stefan-Boltzmann constant (),
- is the absolute temperature of the object (in kelvin).
Relating Detector Measurements to Radiated Power
When using a detector (for example, Horiba xx) that measures intensity, typically the measurement is either irradiance (power per unit area, ) or radiant intensity (power per unit solid angle, ) at the detector's surface. The detector might output measurements in absolute or arbitrary units ("a.u.").
Step 1: Understand the Detector Measurement
Assume the detector measures irradiance, denoted as
at a distance from the radiating object. This is common for many experimental setups.
Step 2: Relate the Detector Measurement to the Object’s Total Radiated Power
For a point-like source or when the detector is far from the object, the irradiance decreases with the inverse square of the distance:
Rearranging for , we obtain:
Step 3: Handling Units
Absolute Units:
If is in absolute units (e.g., ), then:Measure in meters.
Compute directly in watts using the above formula.
If you know , , and , you can verify consistency with
or solve for an unknown variable.
Arbitrary Units (a.u.):
If is in arbitrary units, you need a calibration factor to convert a.u. to physical units, (?? alternatively Wien's displacement law can be used to correlate the peak with known Temperature ??). Check the detector’s documentation for this factor. Once calibrated:and then calculate:
Example Calculation
Suppose:
Your detector reads
at a distance of
(The actual distance used was 0.160m +/- 0.003)Calibration data indicates that
Convert to physical units:
Calculate total power:
Now, if you know that:
- ,
- ,
and you wish to solve for , start from
Plug in the numbers:
Rearrange for :
Taking the fourth root:
Summary of Calculations
Measurement: Record and the distance .
Unit Conversion: If necessary, convert from arbitrary units to physical units (using a calibration factor).
Compute Total Power:
Verification or Solving Unknowns: Use
to verify consistency or solve for an unknown variable such as or .
Reference: Always check your detector’s manual for specifics regarding its output and calibration.