Fab batch part 1
Project Roadmap
(ends Mon 24 Feb 2025 ~39 days)
In this fabrication batch the aim is to produce "3+1" pattern styles using either TiN or Al as a resonator layer materials and, with considerations for uniform thicknesses, and permittivity values of dielectric layers to be composed of either – air, silicon dioxide, titanium dioxide, or halfnia (possibly alumnia).
An experimental set up will be designed to measure
reflection/transmission <=> absorptivity response,
as well as Exitance / modified thermal emission spectrum.
For the latter, a TEC module as a voltage-dependent means for controlling the heat source - 20ºC to 200ºC - would ultimately be used to demonstrate scaling of IV power curves for a measured thermophotovoltaic cell with and without the device (blackbody versus selective emmission).
Notes to self:
What wavelength peak is 200°C.
Multiply that by the simulated or measured absorptivity spectrum.
The 3+1 pattern styles are: variants on the diffraction gratings with micron-scale trench widths; the most symmetric 2-D structure (part of C2v Point groups) followed by various stages of symmetry breaking - referred to as Disk/Hex, Square/Hex, Rectangular/Hex, and Irregular/Hex; simple Hexagonal Close Packed (HCP) structures at both micro- and nano- scale, plus, for now micron scale 2D Moiré patterns achievable through rotating/layering a second HCP structure at specfic angles.
Although if further investigation into Moiré metasurfaces can be justified for the intended application, there would not be any impedements to producing nanoscale 2D moiré structures or, as necessary, 1D to 1D and 1D to 2D structures using the same techniques described herein - with either production of an accurate photomask or marking grid underlay to guide angular placement of the devices to be patterned with a second layer; i.e. some method for orientating substrates for UV exposure accurately.
Time scheduling
The first diffraction-type sets will be completed the same week that the developer solution arrives to compare ALD HFO2 verse TO2 each at 15 mm. Help will be enlisted since precursor costs are above £1000 and this should be justified alternatively alumnia ALD as possible in house.
Assuming x18 part-complete devices consisting of 172nm TiN base layer + a 50nm dielectric layer are held, the following combinations of lithography steps will be attempted:
| TiN + {SiO2/HfO2/TiO2} |
a) + TiN + NR + Etch
c) + NR + TiN + NR lift off
d) + TiN + PR + Etch
c) and d) methods will yield the photomask's patterns/shapes.
All methods would be finalised with a photoresist removal step.
Notes:
b) + PR (+ postbake) + TiN + PR lift-off.
b) is unsuitable for our PR held since desired TiN top layer thickness exceed this resist thickness. LOR C is available to be restocked if needed.
For reference there are 3 academic papers of particular interest. [1,2,3]
Considering these references and the photomasks held, the following width-spacing dimensions of the plasmonic diffraction grating designs would be yielded with the lithography methods:
a) NR etch => x1 {10-10, 23-27, 24-26, 49-51} c) NR lift => x4 {10-10} d) PR etch => x4 {10-10}
Or 9 per dielectric layer of choice {TiO2/SiO2, HfO2/Al2O3} for a total of 18.